Skip to main content

How to login as Administrator on HP Thin Client XP embedded

On Hp (Hewlett Packard) Thin client with Windows XP embedded, when it is turned On, it loading  to windows as a user. with limited facilities, no right click, no control panel, etc.
If you want to go as an administrator, follow these steps :

• Press and hold Shift key

• Click start and click log off (shift key is still pressed until user login form appears )
• Type Administrator in login name
• The default password is Administrator 
.




Popular posts from this blog

How to Enable Hyper Terminal In Windows 7

Hyperterminal Windows 7. Windows 7 Hyperterminal. Hyper terminal is used for data communication via serial port com or TCP/IP Winsock. Unfortunately on Windows 7, Windows 8 and Windows 10 we can't see anymore, even though many of us who still need it, and it is not the solution if we have to go back to Windows XP. The solution :
Read more

Vaio stuck on loading screen after upgrading to Windows 10

My Sony Vaio laptop model : VPCCA16FB with originally using Windows 7 operating system, then now I already upgraded it to Windows 10. All drivers are already installed for each device, everything is OK with this Windows 10 OS. The only problem is:  when I switch the laptop on or restarting it, after vaio logo appears then it stuck with blank screen and it takes about 2 minutes. After that, then it continues to loading Windows. After I googling about the problem, I am not only the one, other people also have the similar problem with their laptops. The cause is in the Ultra Low Power State (ULPS) system. ULPS is a feature or mode in hardware (graphics card) designed to save power by reducing energy consumption to very low levels. Now the problem is solved. If you have the same or similar problem, maybe this below step will help you too.
Post a Comment
Read more

How to deny access to a drive in Windows 10

How to disable access to drives in Windows.  One of ways to  make disable access to drives in Windows (all Windows, Windows 10, Windows 8, Windows 7, also Windows server.. ), you can use Group policy editor . Below are  the steps: 1. Press Windows + R  (to open Run command ), write gpedit.msc at Run column, then hit Enter or click OK.
Read more