Skip to main content

How To Open Battery on Sony Vaio VPCSA36GG

We can't see the battery on Laptop Sony Vaio S Series VPCSA36GG, because the battery is put inside the laptop/notebook.

We need to open the battery not only when the battery must be replaced with  new one. We need to open because some errors in laptop need to disconnect and reconnect the battery to resolve the problem

To open the battery for Sony Vaio S Series VPCSA36GG
• Turn off the laptop
• Open the cover (at the bottom ),
  Use the screw driver to open two screws (see the figure),

  Slide the cover after removing the screws




• Push the key (see figure at point 1) then pull the battery ( see figure at point 2)





To Put back the battery: Push the key (see figure above at point 1) then push the battery down.





See Also :
• How to Resolve: Take a Long Time Booting on Toshiba Portege R500 
• How to enter to Bios setup in Sony Vaio SVS13A16GGB 
• How To Create Contact Us Form For Your Blog 

Labels:

Popular posts from this blog

How to Enable Hyper Terminal In Windows 7

Hyperterminal Windows 7. Windows 7 Hyperterminal. Hyper terminal is used for data communication via serial port com or TCP/IP Winsock. Unfortunately on Windows 7, Windows 8 and Windows 10 we can't see anymore, even though many of us who still need it, and it is not the solution if we have to go back to Windows XP. The solution :
Read more

Vaio stuck on loading screen after upgrading to Windows 10

My Sony Vaio laptop model : VPCCA16FB with originally using Windows 7 operating system, then now I already upgraded it to Windows 10. All drivers are already installed for each device, everything is OK with this Windows 10 OS. The only problem is:  when I switch the laptop on or restarting it, after vaio logo appears then it stuck with blank screen and it takes about 2 minutes. After that, then it continues to loading Windows. After I googling about the problem, I am not only the one, other people also have the similar problem with their laptops. The cause is in the Ultra Low Power State (ULPS) system. ULPS is a feature or mode in hardware (graphics card) designed to save power by reducing energy consumption to very low levels. Now the problem is solved. If you have the same or similar problem, maybe this below step will help you too.
Post a Comment
Read more

How to deny access to a drive in Windows 10

How to disable access to drives in Windows.  One of ways to  make disable access to drives in Windows (all Windows, Windows 10, Windows 8, Windows 7, also Windows server.. ), you can use Group policy editor . Below are  the steps: 1. Press Windows + R  (to open Run command ), write gpedit.msc at Run column, then hit Enter or click OK.
Read more