Skip to main content

How To Set/Enter ESX 4 License key via VClient

When you decided to not entering the License key when installing the VMware vSphere ESX 4.0 or 4.1, because you still didn't have, or you were trying the trial of the ESX. You can  add the license key next time through  VMware VClient.

Where is menu for entering the license key of  VMware ESX 4 through VClient?
• Click on the  host (IP)
• Go to Configuration tab
• Click Licensed Features (in the Software area)


• Cick Menu, then enter the Serial/license key you already have



Other Posts :
Labels:

Popular posts from this blog

How to Enable Hyper Terminal In Windows 7

Hyperterminal Windows 7. Windows 7 Hyperterminal. Hyper terminal is used for data communication via serial port com or TCP/IP Winsock. Unfortunately on Windows 7, Windows 8 and Windows 10 we can't see anymore, even though many of us who still need it, and it is not the solution if we have to go back to Windows XP. The solution :
Read more

Vaio stuck on loading screen after upgrading to Windows 10

My Sony Vaio laptop model : VPCCA16FB with originally using Windows 7 operating system, then now I already upgraded it to Windows 10. All drivers are already installed for each device, everything is OK with this Windows 10 OS. The only problem is:  when I switch the laptop on or restarting it, after vaio logo appears then it stuck with blank screen and it takes about 2 minutes. After that, then it continues to loading Windows. After I googling about the problem, I am not only the one, other people also have the similar problem with their laptops. The cause is in the Ultra Low Power State (ULPS) system. ULPS is a feature or mode in hardware (graphics card) designed to save power by reducing energy consumption to very low levels. Now the problem is solved. If you have the same or similar problem, maybe this below step will help you too.
Post a Comment
Read more

How to deny access to a drive in Windows 10

How to disable access to drives in Windows.  One of ways to  make disable access to drives in Windows (all Windows, Windows 10, Windows 8, Windows 7, also Windows server.. ), you can use Group policy editor . Below are  the steps: 1. Press Windows + R  (to open Run command ), write gpedit.msc at Run column, then hit Enter or click OK.
Read more